Originally Posted by grim1985
My cooler is the Corsair H100 in push pull configuration mounted to the inside top of my HAF X with the two giant case fans on top pulling and the two fans the H100 came with pushing.
Update on my OC, I followed the guide exactly and then it restarted and my fans spun up really high and then it restarted again and ran normally but nothing ever came up on the screen. All my fans where spinning and ran like my system was running. I am assuming that was a bad OC.
Yeah, bad OC, probably not enough voltage. You need to clear the CMOS and start over. Here is how you do that on your motherboard...
There is a CMOS switch on the back I/O of the motherboard.
1.) Press down the “clr CMOS” switch on the back I/O.
2.) Hold down the < Del > key during the boot process and enter BIOS setup to re-enter data.
There is CMOS Jumper :
1.) Turn OFF the computer and unplug the power cord.
2.) Move the jumper cap from pins 1-2 ( default ) to pins 2-3. Keep the cap on pins 2-3 for about 5-10 seconds, then move the cap back to pins 1-2.
3.) Plug in the power cord and turn ON the computer.
4.) Hold down the < Del > key during the boot process and enter BIOS setup to re-enter data.