Quote:
Originally Posted by
Prezesiak 
Can you post your settings? 4.3GHz is my limit of stability at 1.232v. I'm wondering if there is any magic setting that could improve that;)
Sorry for only replying now, wasn't at my PC over the weekend so couldn't get at the settings. Anyways:
vid: 1.1909
offset: + 0.050 (I suspect +0.045 will also work but went the 0.005 higher just in case)
vcore: 1.24 (When under load it swings from about 1.232 to 1.24)
I disabled PLL overvoltage but might try it later
Use LLC at the 50% setting (OC between 4.5 and 4.8 according to BIOS)
Oh, my PLL voltage is set to 1.799 (so basically 1.8) but that is automatically done by the board. I have tried lowering it but when I touch it I almost always get instability.
Other settings are as in the first post.
Quote:
Originally Posted by
Swag
4.5 is the limit for the OC benefit, but I have mine OCd to 4.8 so I can't complain if you want to go higher.
Good job on your OC. Nice temps, my temps hit high 80s when I stress-test and that's when I'm on 1.20vcore. I'm at 1.264 vcore right now and I was only able to stress-test when it was about 50F in my room!
Thank you!
Then I might just stick to the 4.5 and try and adjust some of the other settings to see if I can't lower the voltages a bit.
I see my temps stay mostly under 80 even when folding but it has been kinda cold here the last few days so will have to see what it does when the warm weather comes.
