Stripped all the insulation from my suction line and prepping the unit for a bit of spray paint to tidy it up and did not expect what I found!
- Captube soft soldered to the suction line and accumulator, Bonus!
- Flex line been extended, bad
The original grey wire that was the temp sensor for the stock Mach 2 controller was still on the flex line just cut off at the EVAP end meaning that the Unseen controller was added after all the mods were done on the unit at not at the same time.
Anyway the flex line is what's worrying me as out of all the build logs I've seen and read around the internet I've never seen one thats been extended, is it safe?
The top end also looks more silver or more soft solder in appearance then the bottom half which is obviously braze?
What do you lot think?
- Captube soft soldered to the suction line and accumulator, Bonus!
- Flex line been extended, bad
The original grey wire that was the temp sensor for the stock Mach 2 controller was still on the flex line just cut off at the EVAP end meaning that the Unseen controller was added after all the mods were done on the unit at not at the same time.
Anyway the flex line is what's worrying me as out of all the build logs I've seen and read around the internet I've never seen one thats been extended, is it safe?
The top end also looks more silver or more soft solder in appearance then the bottom half which is obviously braze?
What do you lot think?
