Decided to do the 140 mm fans for radiator...furthest back that would never be seen.
The not so liked part; which will get pushed in under plastic part on fan:
Connected red and black, and cut off yellow there at shink:
Used colorless heat shrink to cover the solder joints:
used my new handy dandy workbench to cut the wires at 26, 27 and 28 iinch.
Layered the heat shrink per joint. while checking with multimeter that there is no overlap against fan solder under sticker.
Soldering turned out nice...Much faster soldering and cleaner than trying to do female fan connectors:
Not sure why i went last cabling with 18 AWG..but hey go with the flow:
Put the whole thing under black electrical tape, as I was going with Dark grey sleeving. Did not do the fan sleeving because it would never be seen.
Both ends with sleeving:
Not much strectching on sleeve required as 3x18AWG in that sleev+ electrical tape..
I did not need any glue here but wanted to try on the purple shade glue, which turns white after drying to see effect. And to see if anything bleeds through sleeving on to finger. Again something that would never been seen from front view:
So these fans done..first 3 . for innermost radiator.
Next have to do the sandwich fan between raidators. And this time with Copper Brown sleeving ; plus the fan sleeving will be totally removed.
And front most fans with front radiator will be Orange sleeving.Edited by Seanimus - 12/2/12 at 6:45pm