Originally Posted by seross69
When you figure out how to talk the wife into a CNC Machine let me know . I had to rent a storage building with power so that i could start on mine my wife said she did not want pieces all over the house.. but at least i will have room for some basic tools.....
Originally Posted by Avonosac
Funny you say that, I've been looking for ways to get access to my old HS's CNC machine. I used to do so much work on it, I could cut out my own parts for pennies on the dollar of what a shop would charge.
Wife will never allow that..I have to get a whole extension to the house or remove the billiards table in the basement to do that. And that would look really odd next to basement bar and kitchen.
Yes there is a full electric kitchen in the basement and a maids bedroom. Why I bought such a big house is beyond me. Went crazy in 2007.
Anyways back to build...Some work done.
Realized i dont need extension cable for USB 3.0 to 3.5 bay device. and I cannot connect both Power & reset switch to a single 10 pin connector. Good thing i checked before doing anything as they go through STH10 through different holes.
This is how the front would look. Minus bottom solid single bay in bottom side, I will change that in the future with vandal switch bay to power down white light inside the center compartment in 2 places.
Between the AQ5 is the NZXT ; which is not mounted ...Waiting for triple short bay mount from Jim @ caselabs. Weeeee...its free since I came up with idea.
This part is getting uglier. New center compartment coming from Jim @ caselabs. And I will put a big sheet of red and brown acrylic to cover all these cables with 10mm spacing for wires behind.
I really don't know what to do with this USB 3.0 cable; it's ugly.
The power/reset/hdd leds are all sleeved now and they go in straight into motherboard. together as one piece. You cannot see it, but the ends are taped (transparent).
Hmm this acyrlic piece that I have left is not that wide. for window on top:
The length is fine however. Thinking if I should buy new one from Evonik. If I do that I will replace front door acrylic from CaseLabs also with Evonik..Very expensive acrylic but it is great for etching and lighting with RGB.Edited by Seanimus - 1/29/13 at 7:45pm