What's up guys! Had some time to tinker with what is going to go where and got the rads and reservoir mounted up. Had to make a few trips to hardware store as i needed a lot of different bolts and such to get everything to go together.
I had to mount fans like this so i can mount the res to the fans and it was kind of a pain since it's hard to find metric bolts in many different lengths even at home depot so i ended with this set up:
The biggest task was to get the 240 rad to go together with fans and the reservoir. The 2 Delta fans will be pushing air through the radiator out of the case and the res will be mounted to the fans. Once again after long time and many different variations of hardware i ended with this:
I will adjust the height of the reservoir once i receive the pump mod kit. I hope it clears the fittings on the rad but even if it does not this is where my 45 and 90 degree fittings will come in:
Mounting the 360 was not to bad as i've had it there before. The only thing is no the Ultra Kaze's are 38mm instead if my old 25mm fans so it was a really tight fit between the fans and motherboard heat sink.
That's it for now. Not much else i can do until my pump parts get here so i can start routing the tubing and bringing it back to life
I am thinking of taking the side door(one with window) to a place with water jet an cut in some design i am thinking either half life theme of rammstein and then adding a black background to it. But i do not yet exactly what design i want so i will hold off on that until i decide.
. The difference in temps is not that big when im running the fans at full speed maybe 6-8 degrees max. I haven't messed with cpu for too long but @ 1.27vcore and 44 multiplier it idles at cool 33 degrees and barely ever hits 60 degree mark at full load. Max temp i had was at 62 after 1 hour of prime. The gpu is running really cool at 33 idle and 45 full load overclocked to 1.2v and max clock speeds in msi afterburner.
