Something's not complete..what is it?

Hey everyone. I'm just about to the end of my military build here, after lots of help from all you guys here on the forums. However, I've encountered a problem. The outside looks fantastic to me, and there are certain aspects of the internals that I love, but everytime I stare at the computer, I get an unsettling feeling. I know something is out of place, something just isn't right (in terms of appearence). I love this baby to death, but I feel there could be more done to the internals to make it more of a "military" build.

This is where you guys come in. I've posted a decent amount of pictures of the case itself, and I'd like you guys to critique it. If I can do ANYTHING different, please tell me. I've got access to paint, a plethora of modding hardware, etc. From the pictures, you'll see I'm going for an ACU theme, composed of OD Green, Coyote Brown, and Grey/Black. I apologize for the bedroom pictures, I've got homework to do Don't worry about being nice, I'll go put my big boy pants on

Before these get mentioned, I have three changes that I have not yet installed, but am planning to install in the near future that will help the look of the build significantly:

--Drain port (coming off the video card block, out the back of the computer).
--EK FC6990 Backplate (Have this sitting on my desk here, but I want to wait to install it just in case I have to take the whole water loop apart).
--New fans. Haven't decided which type yet, but color isn't too big of an issue since I'll most likely paint the impellers.

Without further adue, my pictures:

Thanks! The problem is that I can't figure out what color to put in there. There was originally a green NZXT light strip tucked around the sides of the case, but it blew itself somehow.

The UV lights you see in the last couple pictures are powered by the fan controller in the front, I just found it useless to take "power on" pictures with no lights.

Hmm blue. I don't know if it would fit, but it's worth considering. Thanks

Thanks, I'm pretty proud of it myself =)

That is actually a pretty good idea. I could pick up some "mod-mesh" and try that. The only issue I may run into is attaching it to the case itself. I'll be able to figure out something though. Alright putting "front panel mesh" on my list!

I've also been toying with the idea of switching the tubing, despite all my hard work with the Innerbraid. It looks pretty cool, but I feel like Tygon Norprene would fit the build better. It's not glossy, and doesn't react with lights. I can replace the UV lights with something like white or green. Any input?
Edited by WebsterXC - 9/11/12 at 9:03am