My PA 120.2 Rad is in the top of the case with the ports at teh front. The pump is directly below the outlet for the rad. There is a 2" piece of tubing straight down and the the PMP-400 with my XSPC Res Top. I bought a Swiftech pump heat sink and a fan, however, I cannot install it as the bottom of the pump is too close to the Vid Card.
Where the rad is directly above and feeding the pump, do I really need a res? I'm thinking of switching in the normal XSPC top and letting the rad act as the Res, then there will be room to install the heat sink and fan.
Two questions.
1. Any issues with what I suggest?
2. If I go this way, do I need a fill port? (I actually bleed the loop through the bleed screw on the PA 120.2)
Where the rad is directly above and feeding the pump, do I really need a res? I'm thinking of switching in the normal XSPC top and letting the rad act as the Res, then there will be room to install the heat sink and fan.
Two questions.
1. Any issues with what I suggest?
2. If I go this way, do I need a fill port? (I actually bleed the loop through the bleed screw on the PA 120.2)
Dad's Beast
(18 items) |
|
Dad's Beast
(18 items) |
