Just a couple quick inquiries.
If I have done my home work I should be good to order everything tonight to finish my build in the next week,
so close , so excited.
This has been along time planning and doing. 
Oh and what do you lovely knowledgeable people know about the KOOLANCE PMP-500 PUMP ?
- I am at the understanding that there is minimal performance difference between 1/2" ID and 3/8" ID, is this true?
- 3/8" ID-5/8" OD will give smaller radial bends then 1/2" ID- 3/4" OD, is this true?
Also - As long as the res. is before the pump (feeding the pump) it makes no difference in what way (angle) you mount the pump?
If I have done my home work I should be good to order everything tonight to finish my build in the next week,
so close , so excited.
This has been along time planning and doing. 
Oh and what do you lovely knowledgeable people know about the KOOLANCE PMP-500 PUMP ?






