Overclock.net › Forums › Overclock Marketplace › Appraisals › [Appraisals] Case mod bundle package
New Posts  All Forums:Forum Nav:

[Appraisals] Case mod bundle package

post #1 of 3
Thread Starter 
I have a ton of old case mod supplies that I used to use a while back. However, I have not needed to use them for quite some time, and I do believe that I probably would never need these again. As much fun as building custom cases and modding was fun, I just don't have the time for it anymore. I am looking to get an appraisal for the entire bundle, as I plan on selling it as a whole.

1 Motherboard Tray
2 x 220mm fans, 1 Antec(Molex Connection and 3 speed) which has been used but still in perfect working order, and 1 Brand new Cooler Master(3 Pin connection).
Some scrap pieces of 1/4" acrylic
2 x 600mm CCFL extension cables(Note: these do cause the lights to be a little dim)
60 x 5mm Flat top Red LEDs(1 or 2 may be missing from 1 pack)
60 x 1/4 watt resistors to be used with the LEDs
Some small(probably 26ga) wire to be used to connect the LEDs to the power source
A 6" UV molex Y splitter
A 6-32 tap used for creating the thread for motherboard standoffs
A 7/64 Drill bit to be used in conjunction with the 6-32 tap
A 1/4" - 19 tap used by most water cooling parts(As shown in picture, can be used to create custom reservoirs)
A 11.2mm Drill bit to be used in conjunction with the 1/4" - 19 tap
Several meters of 1/8" and 1/4" high quality thick braided wire sleeving and several lengths of heat shrink wrap

I was thinking somewhere between $75 and $100 shipped. What do you guys think?








post #2 of 3
Thread Starter 
Bump.
post #3 of 3
Thread Starter 
Adding the Rheobus extreme fan controller to this bundle.
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Appraisals
Overclock.net › Forums › Overclock Marketplace › Appraisals › [Appraisals] Case mod bundle package