Originally Posted by lilchronic
Originally Posted by FtW 420
I will need to get the water chiller project running again for multi gpu benching in the warm.
You have the probes in the right spots on the meter, set it to V on the left side of off, 2000M (2v), & will have to check the manual or look closer on the board to see which pins in the header are for what voltage. There should be little plugs & wires in the box so you can stick the ends of the probes in them & not have to hold the probes.
dont think i got that, dude i bought it from i think he kept it along with the mobo stand off's
yea i didnt get that thing but i did check my voltages and there all spot on with what cpu z and what my bios reads
I said it before...(our) mobo is bang on with the voltage regulation, idle and full load. ASRock put out a good product. Let me check my box to see if I got the "official" voltage probes, I never bothered really looking through all the bags since I was just doing a swap with my Gigabyte board so already had everything I needed.
EDIT: Yeah no cables. Just 3 sata cables, 2 molex to something adapters, cd, manual, motherboard plastic bench standoffs, and the backplate/usb3 thing.
I just used these: https://www.sparkfun.com/products/9140
(ebay has them cheaper if you search "female jumper wire"). Plug in nicely into the mobo, and then I push in a male jumper cable that I clip my multimeter onto.Edited by dr/owned - 4/18/13 at 9:13pm