Originally Posted by Systemlord
Well I'm still here after the delidding process, success! Using a double sided paper thin blade (strange cutouts in center of blade) I remove all of the black glue and could believe how easily it wipe away using just my finger nail, I used the entire syringe of Liquid Pro on the processor die. I hope that didn't harm my results, I used MX4 on top of the IHS and my air cooler until the middle of next month when I install my Supremacy together with my ultra high-end water cooling loop..
My ambient temps before delidding was between 22C, my ambient temps at the time of the Prime 95 test picture below after delidding is about 21C, did using the entire syringe of Liquid Pro on the die screw with my results? I mean how do you compare 10 minutes of Prime 95 with 25 hours? I will try to create the environment of when I tested before delidding.
Warning: Spoiler! (Click to show)
"I used the entire syringe of Liquid Pro on the processor die"
thats prolly to much, you dont want it to run out from between the die and ihs, by the pressure,
you can use the seringe to suck some away again..
i used mine to do all sides, die, underside ihs, on ihs and base plate cooler,
all very thin layers
this weekend i did 2 vid cards with it, 1 card twice,
which needed a thick(er) layer because of poor contact, and still have some left
if you run prime 30-40min, thats about the temps you get,
it will go up a bit more after hours run, but not much.. 3-5C max
dont have prime with 4.5ghz,
this is 4.7ghz, to compare temps with,
it stayed under 65C after 30 min primeEdited by VonDutch - 10/29/12 at 1:19am