Originally Posted by PuffinMyLye
The only thing I'm a little unsure of is removing the adhesive glue from both the PCB and IHS. I see in one of the guides the guy used a dremel (which I don't have) and in this guide from OCN Swag talked about just using his thumbnail with some IPA. Can others share their experience with this part of the process as it's a little hard to go through 500+ pages.
I started with just using the thumbnail with some IPA - Then moved on to the Dremel and last I used a toothpick to gently remove the few bits from the corners.
This is way overkill though - You should focus on the stuff that is on the "top" of the IHS, around the frame so to speak - The goal is to make the IHS able to "spin" on the die (Dont go nuts, just a gentle push - it should spin freely) - Then you have direct contact
Anyone got a good recommendation on a PSU for Quad SLI GTX 680 ?
Think I been through 100´s of posts now, with no concrete "Get this - Will run it all just fine" - Was eyeing the Corsair AX1200i, but it only comes with 6 x 8 pin, and I would need 8 x 8 pin. So if any of you "G33ks" could give a friendly pointer, it would be greatly appreciated.
Ps. Know I should ask on the PSU section, but that place is so empty and seldom visited Edited by Gomi - 12/12/12 at 11:49am