Overclock.net › Forums › Case Mods & Cases › Sponsored Builds & Case Mods › [Sponsored] RONSANUT - MERLIN SM8 CASE BUILD ON AIR
New Posts  All Forums:Forum Nav:

[Sponsored] RONSANUT - MERLIN SM8 CASE BUILD ON AIR - Page 6

post #51 of 65
Thread Starter 
Time to start installing the cables.




And mod this panel to wire my own LED switch for the BitFenix Spectre Pro LED fan leds....

post #52 of 65
Thanks!
post #53 of 65
Looking good far! The contrast of the 1200i looks nice. Good choice.
Quote:
Originally Posted by Ronsanut View Post

LOL, Damn that sucker is big ! I have to do the unboxing yet on it. Thanks for the heads up. I plan to SLI with the ASRock but we will see. No worries though as I will be moving to a water cooled build with a new board and AIR coolers will not be an issue.

What board do you plan on using with the water cooled setup? Or you keeping us in suspense on that one?
post #54 of 65
Thread Starter 
Quote:
Originally Posted by Vigilanty View Post

Looking good far! The contrast of the 1200i looks nice. Good choice.
What board do you plan on using with the water cooled setup? Or you keeping us in suspense on that one?
Checkout my Facebook page and you may find a hint.
post #55 of 65
Quote:
Originally Posted by Ronsanut View Post

Checkout my Facebook page and you may find a hint.

Haha. That's what I figured. Well played sir. thumb.gif
post #56 of 65
subbed
post #57 of 65
What are you plans for watercooling or no?
post #58 of 65
Thread Starter 
Quote:
Originally Posted by freitz View Post

What are you plans for water cooling or no?
I will be posting the water cooling kit and setup within the next 2 weeks. It is going to be awesome. Will be using some different water cooling parts than I normally use. It is going to be fun.
post #59 of 65
Thread Starter 

Finished the install of the switch. I offset the switch location so that in the future I could add 1 to 2 more switches to tha panel if I wanted.



Bought some crimp lugs from Radio Shack and drilled out the hole in one of the front bbay panels for the fan LED switch control.
post #60 of 65
Thread Starter 
Since the front panel I/O I selected from Case Labs was all USB 3.0 if I wanted to use the USB 2.0 I needed to buy either a 3.0 to 2.0 adapter or just a 4 port USB 2.0 adapter which I did and installed here.



Also here are some shots of the cable management.



New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Sponsored Builds & Case Mods
Overclock.net › Forums › Case Mods & Cases › Sponsored Builds & Case Mods › [Sponsored] RONSANUT - MERLIN SM8 CASE BUILD ON AIR