Overclock.net › Forums › Case Mods & Cases › Other Hardware Mods › Cables and Sleeving › ATX 24pin pinout Question
New Posts  All Forums:Forum Nav:

ATX 24pin pinout Question

post #1 of 2
Thread Starter 
Hey All,

I just finished sleeving my psu, and i'm getting ready to repin my 24 pin, but looking at this diagram-> (taken from http://en.wikipedia.org/wiki/ATX)




is the image looking at it from the front (where it plugs into the mobo) or from the back (where the wires go in)?

Thanks smile.gif
post #2 of 2
From under, so where it plugs into the motherboard.

I find it easier to redraw it when repinning, as if looking from above, and use some colours to mark the orange 3.3V, the red 5V and yellow 12V.

Edit: might be easier with a pic of an actual connector next to it.

Edited by WiSK - 10/22/12 at 10:16am
Lori Lemaris
(22 items)
 
Felica Hardy
(17 items)
 
Selina Kyle
(13 items)
 
CPUMotherboardGraphicsRAM
Intel Core2 Quad Q9400 @ 3000MHz Asus P5Q3 KFA2 GeForce GTX 550 Ti Kingston 4GB 1333-888 
Hard DriveHard DriveOptical DriveCooling
Seagate 250GB 3.5" ST3250410AS Seagate 80GB 3.5" ST380011A Sony Optiarc AD-7243S Scythe Shuriken 
CoolingOSKeyboardPower
Aerocool Shark 140mm Devil Red Vista 32bit Logitech Deluxe 250 Zalman ZM850-HP 
Case
Cooler Master Gladiator 600 
  hide details  
Reply
Lori Lemaris
(22 items)
 
Felica Hardy
(17 items)
 
Selina Kyle
(13 items)
 
CPUMotherboardGraphicsRAM
Intel Core2 Quad Q9400 @ 3000MHz Asus P5Q3 KFA2 GeForce GTX 550 Ti Kingston 4GB 1333-888 
Hard DriveHard DriveOptical DriveCooling
Seagate 250GB 3.5" ST3250410AS Seagate 80GB 3.5" ST380011A Sony Optiarc AD-7243S Scythe Shuriken 
CoolingOSKeyboardPower
Aerocool Shark 140mm Devil Red Vista 32bit Logitech Deluxe 250 Zalman ZM850-HP 
Case
Cooler Master Gladiator 600 
  hide details  
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Cables and Sleeving
Overclock.net › Forums › Case Mods & Cases › Other Hardware Mods › Cables and Sleeving › ATX 24pin pinout Question