Quote:
Originally Posted by
Rasparthe 
Will a 25K pot work or not enough range? Pin 6 on uP6101 reads 678 ohms to ground. My only 10K pot is on the Asus Silent card, hate to have to pop it off to try this out.
Oddly, the higher of the left side caps reads 1.05v and the bottom one reads 1.49v as I would have expected for the vMem read point.
10K on Pin 4 of uP6161 works just fine for the memory mod. Up to 1.65v right now, the mod doesn't change the voltage on uppermost cap though....
As long as it is a multiturn pot, it should be fine

. Nothing like using a single turn 20k pot, on a mod meant for 10k, and the resolution is so low that putting your screw driver in the adjustment slot moves it just enough that the voltage jumps .2v

(and at the same time, you only want a .05v adjustment, so you resort to hitting the vr with the screwdriver to get it just right)
That reading of 1.05v on that side of the card is a bit weird, but I only called out those read points as it looked like they shared the same plane on the pcb, but you should be defining your read points by what you find is connected to the inductor (as that is what supplies the main voltages anyway). Also weird that they would put a core capacitor that far out... but w/e.
Quote:
Originally Posted by
PizzaMan 
Nuke deserves a lot of reps, he's been working hard keep you guys modded up. Great work in this thread man

Quote:
Originally Posted by
Rasparthe 
No kidding and that doesn't even count when guys like me make it tough for him. Members like Nuke 'em are the reason this website is the best in the overclocking community. Thanks for your help Nuke 'em, appreciate all the time and comments.

Thanks guys

Edited by just_nuke_em - 11/8/12 at 8:34pm