I must say when I was doing all of this there was a lot more frustration than happiness I will let the pictures explain
When I first took off my tubing from my water blocks I saw this instantly... I have no idea how I'm going to go about cleaning it... Suggestions?
The pictures are a bit blurry as I was trying to hold the camera in my hand and the res in my other but there is also a bit of a build up on them as well
Took the fittings off of my pump and saw this....
Then I finally took a look at my fittings and saw this
*note fitting is not scratched just the way I had set up the lighting
And I took the fans off of my rad and I am not too mad with this because I have been running it with out any kind of filter for a while but it all piles up eventually
And last but not least and the biggest problem of them all is that I might not have enough room inside my case to fit everything. Here the PSU is in its spot and the motherboard is where it needs to be but as you can see the GPU waterblock is outside of the side panel. If I put the mother board right against the PSU then it just fits in. I am hoping that once I start to cut more that it will all fit but as of right now I dont really know how to fix this problem :/
So I am guessing that the build up in my block, res, and fittings have to do with plasticizer? maybe? I have no idea but I need to find out what it is and how to fix it now.