Just got my 3930K this weekend and trying my hand at some overclocking. See sig for rig specs.
So far Ive tried 4.8 at 1.5v and 4.6 at 1.48 and no luck. I feel like this is really high voltage for the CPU.
Ive been running prime95 for testing. It will run fine for a few hours then BSOD out of no where. Not a single read error just BSODs and turns off. My temps never go over 75C with my custom loop even at such high voltages. I also have a waterblock on my vrm ( Is there a way to monitor VRM temps btw?).
I also switched out my 24 pin psu cable for a moddiy custom sleeved cable. Not sure if this could be causing problems or not.
Basically just trying to figure out if I have a dud chip or if Im missing some sort of BIOS setting. Its C2 stepping btw. Any and all help is much appreciated. Thanks!
So far Ive tried 4.8 at 1.5v and 4.6 at 1.48 and no luck. I feel like this is really high voltage for the CPU.
Ive been running prime95 for testing. It will run fine for a few hours then BSOD out of no where. Not a single read error just BSODs and turns off. My temps never go over 75C with my custom loop even at such high voltages. I also have a waterblock on my vrm ( Is there a way to monitor VRM temps btw?).
I also switched out my 24 pin psu cable for a moddiy custom sleeved cable. Not sure if this could be causing problems or not.
Basically just trying to figure out if I have a dud chip or if Im missing some sort of BIOS setting. Its C2 stepping btw. Any and all help is much appreciated. Thanks!
TJ07
(18 items) | 
|
|
TJ07
(18 items) |
|
