Hi All!
I initially set up my system to have the H100 in the top-rear of the Switch 810. It was in push-pull intake (blowing down across mobo at the PCB of the Lightning). I wanted to experiment, and try to lower the temps of the Lightning, so I reversed the H100 fans to exhaust out of the top.
I did not really see a change in GPU temps, but this lowered the memory and VRM temps on the lightning considerably (>10c at load). In the process however, I raised the load temps on the 3820 by about 8-10c, which was very disappointing.
I just wanted to get some opinions on the fan setup in my case. You can see the setup in my sig-rig gallery. Also, any suggestions on moving the H100 to the front or bottom. I do not want to impact the temps on the lightning because it seems to run hotter than expected.
Thanks in advance for any feedback!
Cheers!
I initially set up my system to have the H100 in the top-rear of the Switch 810. It was in push-pull intake (blowing down across mobo at the PCB of the Lightning). I wanted to experiment, and try to lower the temps of the Lightning, so I reversed the H100 fans to exhaust out of the top.
I did not really see a change in GPU temps, but this lowered the memory and VRM temps on the lightning considerably (>10c at load). In the process however, I raised the load temps on the 3820 by about 8-10c, which was very disappointing.
I just wanted to get some opinions on the fan setup in my case. You can see the setup in my sig-rig gallery. Also, any suggestions on moving the H100 to the front or bottom. I do not want to impact the temps on the lightning because it seems to run hotter than expected.
Thanks in advance for any feedback!
Cheers!
Mark II Hellfire
(17 items) |
|
Mark II Hellfire
(17 items) |
