post #1 of 1
Thread Starter 
Hello Forum

Socket 1366


I would like to install a corsair H100 into my Coolermaster HAF 932, As part of the installation you have to attatch and backplate(bracket) to hold the cooler in place which is installed on the back on the motherboard

The problem is: The CPU cut out isn't allighned with the brracket on the back on the tray (Using a P6T SE MOBO) whether this means I'll have to take my motherboard out to install the backplate is an annoying thought.

just wondering if anyone with the HAF (with the same or separate cooler and back plate) had the same problem?

If its an issue I'm going to dremmel the bottom section of the CPU cutout on my case to make installtions easier?

Sorry if this sounds confusing/...See the Picture Below. ::::::::::::