Originally Posted by mavisky
H110 should fit just fine. Ive got a 240 rad with a swiftech microres on each side of it and it all fits neatly in the case.
* Zero issues for a corsair h110 with 1 set of 140mm fans.
* Workable with corsair h110 with 2 sets of 140mm fans in push-pull, depending on your mb configuration.
HAF-XB + H110 Corsair water cooler works with either 1 set of fans (Bolt it vertically *behind* the front of the case, blowing towards the rear).
If you try to bolt the 140mm fans onto the front of the case with the radiataor behind it you will run into the problem of not being able to fit the front of the case cover back on.
So thats a push-only or pull-only configuration.
If instead you want a push-pull with the radiator sandwiched between 2 sets of 140mm fans then it depends upon the length of your video card *and* the configuration of your motherboard whether it will fit.
My Asus Sabertooth Z87 has 2 rows of 4 SATA female connectors and a USB 3.0 connector on the front of the motherboard.
With a push-pull fan set, the second set of 140mm fans interesects the space needed for half of those SATA connectors. In otherwords you are down to 4 instead of 8. Not a big problem.
The USB 3.0 connector is a pretty snug fit (I used a pair of vice grips to hold it and push it in)
In addition with a longer motherboard you should put your push-pull fans on *last* because you won't be able to get your motherboard out unless you unbolt that last set of fans from the radiator.
NOTE: At the Fry's Electronics store the unusually helpful Supervisor browsed this very forum in the store before recommending I buy this HAF-XB and H110 combo. So I wanted to write back with this note. (Good job Fry's for redeeming yourselves a bit from years of less-great service)