Mutch talking and no pictures thats not me.
I got the need of showing my progress \ and share my mistakes e.t.c.
I told i the last update that i made my first harnes i didn't show the picture i dont no why i did not show it "mayby i find it not gut enough to show"
I always say "you can always do better" Al hanging loos because i wait on the last to fans to arrive.
And i have already cut vinyl to cover the colred wires from the fans.
My first harnes i made where the ons for the bottom fans. I made 2 harnesses and the come together behind the case.
Just with the door off and the pictures made on an angle you can see the hole i made for the wires to pass tru the back.
At the back you see a bundle of wires in a roll with a red wire tide to the 12 volt wire. I still wait for the rma from aqua for one PA2 and the 2
other PA2 i purchase a few days ago. When the are installed (4 in the back and 4 in the pedestel) i wil adjust the lenght of the wires and sleeve them also.
Waiting for the last 2 fans. And after i put the vinyl on the fans you wont notice the colored wires and the stickers.
I had to take measurements for the acryl pannels i wanted to purchase for ligthning the bottom. I wrote the measurements on a piece
of paper after this i went on with cutting out cirkels in the vinyl. After this the small paper was gone. Shi.......piep. Have to do the
measurements over again tomorrow.
mesh is fromt the pedestel stil need to make a frame or coverplate to tide the mesh down.
More on friday.