Update 55 "or just busy \ Acrylic top for the lightpanel"
The thing is i love the bleu\ chrome light from the blocks and res. So i'm trying both top pannels the opaal color version and the clear edged one.
I made a paper mal wich i'm going to put under the plate so i can see the 1 cm marking where the dremel have to make a v shape.
I have a big plate with 2 cracks in it. "thats why i got it for free YES". Because it is second hand there is no protection film on it.
I use paper instead of the film. I draw the lines on the panel and mask the other side. also a extra path so the jigsaw slide over.
The new fine cuttingblade did the job perfect. Just a little sanding and polishing. "after i fit the panel in the case"
avery time i search for a tools i have to put the wooden plates aside. grrrrr. need more space.
The panel dont fit yet but wil be after i finish working on it.
For the engraving i made a drawing in AutoCAD en use it to guide the dremel. Befor i start i will do a smal piece so i can
see i it going to work.
After the coffee 20:00 hour i went back to my workshop to finish the raw panel.
YesYes i now bad picture wel i make a better one tomorrow . Just finished the top panel 8mm.
I have more then one option for the frame:
- 4 L strips in the corners a small piece acrylic with a screw in it. behind the acrylic i can make a hole to pas tru the wire from the leds.
- 4 flat strips up to the edge of the frame (covers the front of the acrylic too) and the top loose on the strips.
Because i now have the exact measurements of the top panel i can make the other panel (opaal tomorrow).
- in the morning (the mechanic of the phone company "no phone sinds the update the system"
- afternoon purchase 2 new office chairs (wife happy i hope)
After that shopping for dinner and do som more work on the case "i hope".Edited by TATH - 5/30/13 at 1:19pm