Update 67 "sleeving wiring of the left res"
Still waiting for the delivery of the acryl backplates i thought i already can do som preperation on the wiring of the res.
I took out the res and taken of the bottom scews:
- measured out the length of the sleeving i need (± 6 cm);
- shorten the wiring because i dont need al the wires. (I wil solder later 2 wires to the bundle when i now the
exact location where the wires com out at the back);
- for testing if the leds stil work i solder the wires together ( got a slide problem now with the sleeving) now i have
to use a small tool to help to pas tru the wires tru the sleeving without braking the wires)
As a tool to help me passing tru the wires i use a pen knob,
When i put back on the bottomplate of the res i also pas tru the wiring tru the hole of the bracket.
I have to wait with the end because i still have to solder 2 long wires. First i make a drawing to figger out where al wires have to meet at the back.
Yes always testing. And the angle of the sleeving is oke.
I also have to find out if i need to drill a hole (again) in the case for the extra wires from the res:
Glad i stil have a few wires for testing.
Ahum yes thats about 1,5 cm. Measured it out at the back. Yes another hole another hole to drill in prescious.
Now i no that i have enough room between res and pumps i also can start with the making of the horizontal crystal link tube to connect the two pumps with each other .
Also got the switches out of the package to see how it works. "Yes i admit its a new chapter for me" I now + and -
There is a drawing with it. In the middle + and - and left and right 2 connector pins. I put on the power and ground wire and used a multi meter to test id something hapens on the other pins. the led stays on and nothing hapens on the other pins. yes i think i need help on this part. "first check the buildlog of Seanamus448" .
Closup of the pins.
18-06 more parts received:
2 new PA2's (still have to sent back the 2 fault ones\already sent back one before but receive nothing back yet);
1 packkage black acrylic plates (sh... need on more plate for the front)
2 bags fibration dampers (yellow) for the pumps.
Yes and i still need more things. This doesn't mean i cant go on building.
More tomorrowEdited by TATH - 6/18/13 at 8:58am