Update 127 "working on the pedestel"
The more i look at the case the more i love it.
Today i want to build in the quick disconnects (panel versions) to do this i have to take over the drilholes from the acrylic panel.
Bart says whe need to buy a forklifttruck to lift it. Whe wil now it in a moment. No sorry Bart i can still lift it.
I bolted the case and pedestel together to be shure i draw the drillholes at the right place.
Just a picture to dream away.!
Yes yes one more before i go further with the build.
One glimp of the quick disconnects i planning to put in.
So now i'm going to hurt the pedestel by drilling 2 more holes. Wath a mess do you get with drilling.
Forgot to mention i first took 10 minutes to get out al the dust particles in the case.
Yes the fit.
Because it perhaps com in handy i have two different sizes of bitspower connects to adjust the height of the tubing.
First lets see if the fit tru the drillhole. Just as i thought the dont. So i have to screw the 90 degree rotary from under the quick disconnects. Lets see how much space ther is left for the tubing.
I bought a tube full of E22 tubing but i can find it. Grrrrrrrrrrrrrrrrrrrrrrrrrrrrrrr where is it. After searching the complete
workspace is was looking up. Yes there the are. Now i can go on with the build again
I use one multilink just for the fitting of the tubing. I need to make the tubing to fit and use a piece of sandpaper to turn the tubing on.
This way i want to sand the tubing equaly.
Almost forgot this tool "joep showt me" to get a slope edge on the end of the tubing.
There is just one thing i did wrong i bought i at the wrong shop cost me 20 euro instead of 8. grrrr.
I put the tool on the workbench hold it down with one hand. Then i put the tube in with the other hand and turn the tubing.
This way the edge has a equal curve.
To check if the edge is oke i use a magnifying glass. Check yes oke.
Yes fits oke. need 2 more to do but i have to wait on the bent table my college made for me.
Putting the case on the pedestel to see how it looks \ fit. Now i have to work on the acrylic panel.
I change the panel by making a square cut in it so the quick disconnect fits better. I wil make a cover piece later.
I put the panel back in. I think TPE-331\ Mandrix is\ are right i need another pedestel
playing more with the connectors to see how i can make the connection.
Altho i have a ox full of bitspower connectors left i ran out of 90 degree rotaries. There where 9 left this morning.
Need to buy som more i think. I hate a empty box.
Its almost 18:00 hour its time to end the build for now.
Hope you all enjoy the revieuw from today as i do.