Overclock.net banner

BitFenix Colossus VENOM Edition + Corsair H100

925 views 1 reply 2 participants last post by  mark_thaddeus 
#1 ·
Hello, I've just bought the BitFenix Colossus VENOM Edition case, And I have an H100 cpu cooler... Just want to know if anyone has these same two items or if anyone has any idea on a way to mount the H100 inside. I plan on removing the top 240mm Fan and placing there. Anyone have any better ideas?
 
#2 ·
If you don't plan to do any mods to your case, placing the 240 rad up top (set to intake and use the rear as the exhaust) is rally the best and easiest way to go.

Have you tried fitting the H100 up front to where the 200mm fan is? If it fits there that would be a nice place to do a push / pull config. You'd have to remove the drive cages though and re-position your hard drives /ssd to the optical bays. This would obviously entail some modding since the drive bays aren't removable, correct?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top