Originally Posted by qiplayer
There isn't much way to do things differently. A torch screwdriwer and unscrew. But those are very thight and very small
If people are stripping torx, they are likely trying to fit something else in it besides the official, copyrighted T6-Torx head.
I have seen very few fan controllers with an actual PWN (4pin) header built in, looks like that one is also lacking in PWM headers. The good news is, I will be ordering auqero 6 as soon as it shows up on PPC or FCPU, or some other US based retailer.
I think it may be not having enough water in my res (if that makes sense) I noticed I have suffered a bit of evaporation, so i'm down to the lowest fill line on the res. I may end up RMA'ing this unit anyways before the factory warranty runs out. The warranty seals are still intact, so I might as well swap it out for a new unit before throwing it into the 900D rebuild. It did the same thing this morning when powering up. So, today after work i'll have to tear out the res & top it off.
I also started a ticket on the swiftech forums to see if anyone else has ran into this issue. If it was a bad pump one would still run, it's highly unlikely that both are going @ the same time.