Originally Posted by Agent-A01
What do you mean first command ok, 2nd command. You obviously done something wrong.
If you ran each command by itself, the result would be nothing. These commands must be ran in tandem with each other.
First command sets a given voltage, the 2nd and 3rd pair enable the controller to go into manual voltage mode. If you set each command one at a time, you have not followed directions.
3rdly. It is virtually impossible
for a card to blow under zero load. I have applied 1.6volts on my titan at IDLE to verify the range of acceptable voltages. My card did not blow up, so i know typed something wrong.
If you had followed my instructions as i said correctly, which i said clearly to just run those commands and check voltage under msi ab with a screencap.
I dont know if your lack of fluent english was the problem or something else.
I have verified with a friend with a EVGA SC ACX that setting manual voltage does indeed work, i will see later if he can provide a screen cap.
The explanations you have been given.
You've messed with the controls.
Yours is the problem of your gestures like the problem is your rma the card.
I have recommended you to friends what to do BEFORE you enter commands.
At the moment I have no 780ti / titan black but they are the owner of a Titan and the controls suggested by agent I have solved all the problems related to the LLC 0.
I had my pc restarts LLC with 0 games were unstable at certain frequencies LLC with 0.
With the commands I suggested a correct reading of the LLC as an explanation of Agent and the maximum stability of my Titan.
An example with heaven I could not get over 1306mhz core - 7000 MHz memory now with the string suggested by Agent can achieve fluency in 1402mhz - 7434mhz memory.
I have all the screen of the case is with CLL with either 0 Reads LLC as suggested by string.
Best wishes for your next card.