Overclock.net › Forums › Components › Memory › BSOD 101 Tight RAM Timings
New Posts  All Forums:Forum Nav:

BSOD 101 Tight RAM Timings - Page 7

post #61 of 63
Thread Starter 
Nevermind for now.
Edited by kevindd992002 - 4/24/13 at 8:30am
post #62 of 63
Thread Starter 
IS BSOD 0xF4 related to RAM overclocking? I got it when I started tightening secondary timings but am not sure if this is the cause because I also updated some new drivers (Intel RST, Intel MEI, and Realtek HD Audio).

More results:

I'm pretty much STABLE at these settings:

2133MHz CL8-11-8-28-2T
1.74375V DRAM voltage
1.100 VCCIO voltage

DRAM RAS# to RAS# Delay=4
DRAM REF Cycle Time=90
DRAM Refresh Interval=auto (system sets it to 8320)
DRAM WRITE Recovery Time=8
DRAM READ to PRE Time=4
DRAM FOUR ACT WIN Time=auto (system sets it to 33)
DRAM WRITE to READ Delay=4
DRAM CKE Minimum Pulse Width=5
DRAM CAS# Write Latency=6
DRAM RTL(CHA)=auto (system sets it to 37)
DRAM RTL(CHB)=auto (system sets it to 38)

tWRDR(DD)=Auto (system sets it to 1)
tRWDR(DD)=Auto (system sets it to 4)
tRWSR=Auto (system sets it to 4)
tRR(DD)=Auto (system sets it to 3)
tRR(DR)=Auto (system sets it to 1)
tRRSR=4
tWW(DD)=Auto (system sets it to 3)
tWW(DR)=Auto (system sets it to 3)
tWWSR=4

What else can I improve? Thanks.
Edited by kevindd992002 - 4/26/13 at 7:43pm
post #63 of 63
Thread Starter 
BUMP!
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Memory
Overclock.net › Forums › Components › Memory › BSOD 101 Tight RAM Timings