Overclock.net › Forums › Components › Memory › g-skill rma, my hypers are dead (received replacements and got a problem)
New Posts  All Forums:Forum Nav:

g-skill rma, my hypers are dead (received replacements and got a problem) - Page 4

post #31 of 50
Quote:
Originally Posted by richie_2010 View Post

I've been offered the F3-14900CL8D-8GBXM set should I take it

They are trying to sell you more density...but those can be anything at 1866mhz and those timings.
I think you can take them, resell them and grab Crucial Ballistix Elite 2x4gb 1866mhz cl9 1.5v instead. Similar behavior as Hypers as Schmuckley said, you can probably tighten the timings a lot at 1900mhz and 1.8v.
They love voltage biggrin.gif
post #32 of 50
Thread Starter 
They just emailed me again they have found the last remaining set of F3-17066CL8D-4GBPS
In there possession and sending me them smile.gif
post #33 of 50
Amazing!!! biggrin.gif
post #34 of 50
Thread Starter 
I know biggrin.gif, id thought since the age n the rareness of then they wouldn't have any
I'm praying they work, I asked em to test but the Netherlands site doesn't have the capabilities it's just a warehouse/ distribution place.
post #35 of 50
Unlike other brands, G.Skill recycle ICs a lot - this allows them to replace stuff like D9GMH, PSC and Hypers even in 2013.
The 2133C8 you're going to get are very likely to have a '2013 serial number meaning these were recently produced, may be even using some of the good ICs of the sticks you sent in.
post #36 of 50
Thread Starter 
Well he said they already had them but not received mine, ill find out if they fobbed me off when I get them n test them.
Thanks for the heads up though but 8 8 8 24 on any other 2133 sticks is going be hard ain't it
post #37 of 50
The only hard part of your 2133C8's spec is tRCD 8 at 1066MHz, the rest is easily done by BBSE, X and even T-series PSC.

I don't want to set your hopes too high, but at least on D9GMH, BBSE and PSC, the stuff RMA dept sent after the memory went EOL overclocked quite a lot better than the stuff you could get in retail.
post #38 of 50
Thread Starter 
The only way of me finding out then if I remove the heat spreader n check or try the 6 6 6 18 at 1600
post #39 of 50
Thread Starter 
I have good news, I received my repacements today, only received the email this morning to say they were shipped out
post #40 of 50
Thread Starter 
I have installed one stick into the board and running memtest it shows ddr400 cpuz shows that im running at 800 so 1600

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Memory
Overclock.net › Forums › Components › Memory › g-skill rma, my hypers are dead (received replacements and got a problem)