post #1 of 1
Thread Starter 
OK, so I got my XSPC Raystorm EX360 kit with the D5 pump installed and leak tested. So far so good. I have a question about my temps though. My setup is an Asrock Z77 Ext.4 with an i5 3570K @ 4.4. Cpuz reports a vcore of 1.192 running IBT. Do these temps look OK? They are about 5-7C lower than my H100 was. I'm using Prolimatech PK-1 under the Raystorm.

Edit --- I'm using the three included 120mm fans @ 2000 rpm. I've got them on an old Sunbeam 4 channel fan controller and usually run them about 60% on idle though they were at 100% for the pic. Also, the pump is at 4.

Thanks

Uncle Paul
(14 items)
 
  
CPUMotherboardGraphicsRAM
Intel i7 2700K Gigabyte z77x UD4H Gigabyte GTX 670 Windforce G.SKILL Sniper Series 8GB (2 x 4GB) 240-Pin DDR... 
Hard DriveOptical DriveCoolingCooling
OCZ Agility 3 LG Bluray  XSPC Raystorm water block XSPC EX360 
CoolingOSMonitorPower
XSPC D5 Dual Bay Reservoir Windows 7 64bit Pro Acer 27inch LED Corsair 850W 
CaseAudio
Cooler Master HAF 932 Logitech Z680 
  hide details  
Reply
Uncle Paul
(14 items)
 
  
CPUMotherboardGraphicsRAM
Intel i7 2700K Gigabyte z77x UD4H Gigabyte GTX 670 Windforce G.SKILL Sniper Series 8GB (2 x 4GB) 240-Pin DDR... 
Hard DriveOptical DriveCoolingCooling
OCZ Agility 3 LG Bluray  XSPC Raystorm water block XSPC EX360 
CoolingOSMonitorPower
XSPC D5 Dual Bay Reservoir Windows 7 64bit Pro Acer 27inch LED Corsair 850W 
CaseAudio
Cooler Master HAF 932 Logitech Z680 
  hide details  
Reply