Monitor finally came today, had to go to the FedEx distro to pick it up because they came while I was a work. Totally worth it. Was going to say that the panel had two dead pixels in the bottom right area but I can't seem to find them anymore. Black magic maybe?
Anyways there is BLB along the bottom. I put a strip of electrical tape along the bottom of the panel when I was pulling it apart to take the stand off. It seemed to help lessen the original spot a little but another area popped up along the bottom a few inches away. I am not sure that I actually did the tape right. Was kinda winging it because I hadn't actually seen someone else going through the actual process of putting on the tape. I had read about people doing it this way and that way and decided to just put a strip all the way across the bottom since that was the only side of the panel with bleed. Any feedback would be appreciated.
And has anyone else noticed that the vesa mount holes seem rather shallow? The screws that came with my arm work find on my 24" ASUS monitor but they don't go in all the way on this X-Star.