Quote:I used a butter knife to pry the casing off lol - but you might want to be careful as i knicked the plastic in some places. Just put it into the seam and twist, the first time you take the casing off its a bit stubborn so try 2 butter knives to lessen the pressure on one point Just keep turning until you hear a pop - dont worry it wont break, just keep aware of the case.
Make sure you have a set of screwdrivers, because the panel that houses the board uses something like 1mm philips head screws (very tiny) and youre going to need to remove it to get to the other screws that hold the metal frame in place
The metal frame uses tabs or something to keep it in place, IIRC i had the panel face down so i can use my butter knife to pry the tab out and over the latch thing Once the frame was loose i flipped it back onto its back and lifted it out and away so i can straighten it.
Good luck - its not hard, just be careful and youll be fine.