Got lots done today, finished up work on the motherboard surround and epoxied the standoffs for it into place, also finished up the bends going to the CPU, this is the fourth time I have done that run and I finally think I have nailed it, the tubes are almost perfectly parallel
I also put the graphics card back in and found an issue, the pipe going from the pump down the side of the side radiator was interfering with the PCIE connection of the card so I have had to re-route it right to the back of the case and then it follows the other flexible tubing run down the side of the case, across the front and round onto the door. We are almost there now, I need to make a mount for the adapter going from hard tubing to flexible tubing on that new run and then I need to draw up and 3D print mounts for the graphics card, once that is done I need to cut the ZMT tubing to length and install that and also order some more fittings (2 new C47 fittings for the GPU block) Do you guys think I will need more than 1 liter of coolant for this loop??
I have also taken some photos through the PSU opening to show just how tight everything is when the door is closed, in the last photo you can see how much wastage I have from the acrylic tube, that is just stuff from the last 2 weeks :/