Overclock.net › Forums › Case Mods & Cases › Builds & Case Mods › Case Mods › Retooling My Project
New Posts  All Forums:Forum Nav:

Retooling My Project - Page 2

post #11 of 17
Thread Starter 
Here we go..Moved the hard drive cage over..Installed the MB and fittings..starting to get excited..biggrin.gif





post #12 of 17
Thread Starter 
I took the Tin logo shields off of the heat sinks..a way nicer look for the "Dark Nite"lol had to name it a.

And I want to put two cylindrical reservoirs on the right side of the HD cage..The hoses will be black but the fluid will be blood red. I want it to show in the two reservoirs and on the front dual reservoir. Ill use the red addition Corsair memory as a highlight..and see how it works out..

.

Lots left to do yet..A poor man has to work slow..l..This is rejuvenating and a blast to build out..
Edited by take2daily - 6/19/13 at 5:35am
post #13 of 17
Thread Starter 
Ok update..I finally chose an external reservoir to use along with my Koolance dual pump res..as a calming station. Its ordered and on the way..

CREATOR: gd-jpeg v1.0 (using IJG JPEG v62), quality = 90

There is barley enough room between the hard drive cage and the large exhaust fan in the front to accommodate this addition..Almost there..RAM and cooling fluid..there is quite a lot written about cooling fluid and it seems like water works great but Feser one has all the bells and whistles for a non conductive fluid. So I will give it a go..
Edited by take2daily - 7/10/13 at 7:49am
post #14 of 17
Thread Starter 
There is barley enough room between the hard drive cage and the large exhaust fan in the front to accommodate this addition..Almost there..RAM and cooling fluid..there is quite a lot written about cooling fluid and it seems like water works great but Feser one has all the bells and whistles for a non conductive fluid. So I will give it a go..[/quote]

Installed..sort of..I have to bolt it down and figure out the best route for the tubing..


Edited by take2daily - 7/10/13 at 7:49am
post #15 of 17
Thread Starter 
The cooling loop.. I had this all installed..Boy thats a big mistake..The pumps were making all kinds of noise because of air..Best setup the loop outside and buy some quick connects to complete the whole mess..so that you can get it running smoothly and then without loosing the prime and the fact that it took half the day to clear the lines of air..Install it back into the computer and connect it up.. Lesson learned..


Edited by take2daily - 7/20/13 at 3:19pm
post #16 of 17
Thread Starter 
Ok I finally got this thing back together..I used some quick connects and changed the HD config a bit..Trying to tiddy up the wiring..I'll make it cleaner as time goes on..Also some red lighting might be fun..Nothing major but for my first WC build it went well..I learned that planning is key..;-)..
post #17 of 17
Thread Starter 
BTW the CPU is running at just below 36.0 degrees C. at rest..
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Case Mods
Overclock.net › Forums › Case Mods & Cases › Builds & Case Mods › Case Mods › Retooling My Project