Originally Posted by PaRaDoX
It's a little hard to see in this pic but the BT comes with a I bracket and two screws and a few nuts that you should use. The manual says clearly not to use it with the plastic backplates
well the only problem is... the nuts are so damn small.. how am I supposed to get them tight.... there is no way haha i tried hard but its still moving a little. and yes I did read the instruction and used the I backplate. (The DFI board screws were to short) and the longer ones did not fit on the backplate. so I was forced to).
EDIT: AS we speak I am lapping my old 3200+. Seeing If I can't get the shiney look and nice copper look
. If I succeed I will do it to my 4400 and then my tt... its hard to lap the tt its so big and not very handy haha. I might post some pictures of the 3200 later tonite.