Overclock.net › Forums › Distributed Computing › Distributed Computing - General › [Official] BitCoin LiteCoin DigitalCoin and all Crypto Currencies Club And General Information Thread
New Posts  All Forums:Forum Nav:

[Official] BitCoin LiteCoin DigitalCoin and all Crypto Currencies Club And General Information Thread - Page 799

post #7981 of 22341
Thread Starter 
Quote:
Originally Posted by Darth Scabrous View Post

I'm at 3.6 million now.

Need to change my settings for 2 of my 280x. I was thinking 1050/1500 at i 13 11200. Would that work?
depends on the card...
post #7982 of 22341
I have the HIS iPower IceQ X². Right now, I have them at 1080/1500, with i 13, thread concurrency 11200, and workload 256. I'm netting around 680kh/s.
post #7983 of 22341
Anybody else having problems with nutcoin? Can't access website, for neither coin nor pool.
post #7984 of 22341
Quote:
Originally Posted by Darth Scabrous View Post

Anybody else having problems with nutcoin? Can't access website, for neither coin nor pool.

I'm mining that right now with no problems
post #7985 of 22341
I can mine the coin no problem, still getting payouts, I just can't access the sites for some reason
post #7986 of 22341
I'm building a rack right now where the MB will sit ontop of plywood. Do you think I would be ok if I just screwed the MB Standoffs to the MB and just set it ontop of the plywood? They do not need to be physically attached to a base right?
post #7987 of 22341
Quote:
Originally Posted by blkdoutgsxr View Post

I'm building a rack right now where the MB will sit ontop of plywood. Do you think I would be ok if I just screwed the MB Standoffs to the MB and just set it ontop of the plywood? They do not need to be physically attached to a base right?

Be sure to have ESD protection at all time when you'll be working on it. But still, it just don't sounds like a good idea to me tongue.gif
post #7988 of 22341
Quote:
Originally Posted by theturbofd View Post

I'm mining that right now with no problems

The website is down for me as well.
Quote:
Originally Posted by blkdoutgsxr View Post

I'm building a rack right now where the MB will sit ontop of plywood. Do you think I would be ok if I just screwed the MB Standoffs to the MB and just set it ontop of the plywood? They do not need to be physically attached to a base right?

Heck you could even sit the motherboard directly on the wood. The wood will not conduct electricity so it won't affect the motherboard. Or you could place a piece of cardboard between the between the wood and the motherboard. Then take about four long screws and drill them in the four motherboard stand off screw holes just to hold the board in place. Cheap and easy.
Edited by RAFFY - 1/10/14 at 6:46am
post #7989 of 22341
My Work in process. Just gotta cut OSB and put it all together.

post #7990 of 22341
720k NutCoin in the last 10 hours with my 2.1Mh/S
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Distributed Computing - General
Overclock.net › Forums › Distributed Computing › Distributed Computing - General › [Official] BitCoin LiteCoin DigitalCoin and all Crypto Currencies Club And General Information Thread