Overclock.net › Forums › Cooling › Air Cooling › Corsir DOminator Platnum
New Posts  All Forums:Forum Nav:

Corsir DOminator Platnum

post #1 of 3
Thread Starter 
Hello , I ran into a problem with my Corsiar ramsticks,. Well I purchased a Full water block for them and find out they do not fit water Blocks because they are Longer than the Normal DDR3 PCB boards. Now the original heat spreaders are garbage and now Im stuck with Nothing. Any one know what type of heat spreader or any other solutions for these Ram sticks. I hav:D:rolleyes:e looked at a lot but none are tall enough to fit the Dominator series. Any help would be great. Thanks
post #2 of 3
Maybe this:

http://www.ekwb.com/news/287/19/
post #3 of 3
Thread Starter 
You , That's what I had. I think they might of just sent me the wrong ones. The PCG board on them is about 3/4 inch taller than regular DDR3. SO when I mounted them half of the CHip and board it self was not covered. So I sold it after that. So im think single ram sinks is the only way to go. I havnt seen one that will fit the chip it self. Ivebeen on PreformancePCs all week looking at all there stock. None will fit.
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Air Cooling
Overclock.net › Forums › Cooling › Air Cooling › Corsir DOminator Platnum