Overclock.net › Forums › Intel › Intel CPUs › Haswell Overclocking Guide [With Statistics]
New Posts  All Forums:Forum Nav:

Haswell Overclocking Guide [With Statistics] - Page 835

post #8341 of 19539
Thread Starter 

I did some testing and obviously I throttle @ 4.3ghz/1.25v at max settings for Linpack. So I went to 4.2ghz/1.2v, 34 uncore 1.18v Vring. 1.9 Vrin. Stock ram. Temps were fine but crashed. 4.1ghz net me 86C peak in 5 minutes of testing.

 

4.1ghz/1.2v = 86C with D14 @ Linpack max.
That is utterly insane.

 

I probably could've snuck in 4.2ghz if I were Linpack-or-Die and I took my time working my way up to 4.2ghz. No thanks. All of the temp tests are now done. Going to do the rest of the finishing touches tomorrow and the chart should be updated for the new data. I'll get the Vrin might heat up CPU thing tested as well. Might as well redo the numbers for Vring increase as well.

 

After that, it's a long look at LLC first, and second, Cstates/Adaptive voltages.

Quote:
Originally Posted by Peybol View Post


BSOD in x264 in about 10m
Is that worse or better than before?
Undelwalt (2017)
(29 items)
 
 
Celapaleis (2013)
(16 items)
 
CPUMotherboardGraphicsRAM
7600k @ 5.197/1.392 1.392v z170 Asus Hero EVGA 1080ti SC Black (2100/6250) x2 8gb GSkill Trident Z 3600 @ 3804 15-15-15-32-2T 
Hard DriveHard DriveHard DriveCooling
Samsung 950 Pro 512gb (Undelwalt) WD Red 2tb (Pack Yak II) Seagate Expansion Drive 5tb (Phoenix Down II) 3x560mm HardwareLabs Nemesis GTX 
CoolingCoolingCoolingCooling
XPSC Raystorm Pro Watercool Heatkiller 1080ti Full Cover Waterblock EK XTOP Revo Dual D5 (Serial, PWM, v4) EK ZMT (1/2 - 3/4 ID OD) 
CoolingCoolingCoolingCooling
14xEK ACF (Compression Fittings) EK x4 250 (v2) Distilled Water + PT Nuke (Copper Sulphate) 24x140mm Silent Wings 3 
OSMonitorKeyboardPower
Windows 10 Pro 64bit Catleap 27 Inch 2560x1440 IPS 60hz Display Coolermaster Storm Trigger (Brown Switches) EVGA P2 1000w 
CaseMouseMouse PadAudio
Corsair Air 540 Logitech G Pro Tek Syndicate "Raze the World" Desk Mat O2 + Odac by Mayflower Electronics (Rev A) 
AudioAudioAudioAudio
Sennheiser HD 800 2xKrk Rokit 6 G2 Blue Yeti (Grey) Rode PSA-1 Arm 
Other
Aquaero 6 LT + Aluminum Heatsink 
CPUMotherboardGraphicsRAM
i5 6600k Delid @ 4.848/4.848 Asus z170 Hero MSI GTX 980ti @ 1499/4082 1.25v/134% Power 2 x 8gb Gskills Ripjaws V 3131 16-16-16-32 
Hard DriveHard DriveHard DriveHard Drive
Samsung Pro Series 840 256gb (Celapaleis) 1 TB Samsung Drive (Pack Yak) Samsung Pro Series 850 256gb (Celapaleis Reprise) Phoenix Down (External Backup) 
CoolingCoolingOSMonitor
Noctua D14 Kraken x61 Push-Pull for GPU Windows 10 Pro Catleap 2560x1440 @ 60hz 
KeyboardPowerCaseMouse
CM Storm Trigger Brown Switches EVGA Supernova 1000w P2 Corsair 540 Air Razer Abyssus 
Mouse PadAudioAudioAudio
Steelseries QcK Mini Blue Yeti Microphone Objective Dac + Amp Sescom AB Switch 
AudioAudioAudioAudio
Krk Rokit 6 G2 x2 Radioshack Ground Loop Isolator (For Rokits) Wooaudio Aluminum Headphone Stand Sennheiser HD 800 
AudioOther
Logitech c920 Webcam NZXT Sentry Mix 2 Fan Controller 
  hide details  
Reply
Undelwalt (2017)
(29 items)
 
 
Celapaleis (2013)
(16 items)
 
CPUMotherboardGraphicsRAM
7600k @ 5.197/1.392 1.392v z170 Asus Hero EVGA 1080ti SC Black (2100/6250) x2 8gb GSkill Trident Z 3600 @ 3804 15-15-15-32-2T 
Hard DriveHard DriveHard DriveCooling
Samsung 950 Pro 512gb (Undelwalt) WD Red 2tb (Pack Yak II) Seagate Expansion Drive 5tb (Phoenix Down II) 3x560mm HardwareLabs Nemesis GTX 
CoolingCoolingCoolingCooling
XPSC Raystorm Pro Watercool Heatkiller 1080ti Full Cover Waterblock EK XTOP Revo Dual D5 (Serial, PWM, v4) EK ZMT (1/2 - 3/4 ID OD) 
CoolingCoolingCoolingCooling
14xEK ACF (Compression Fittings) EK x4 250 (v2) Distilled Water + PT Nuke (Copper Sulphate) 24x140mm Silent Wings 3 
OSMonitorKeyboardPower
Windows 10 Pro 64bit Catleap 27 Inch 2560x1440 IPS 60hz Display Coolermaster Storm Trigger (Brown Switches) EVGA P2 1000w 
CaseMouseMouse PadAudio
Corsair Air 540 Logitech G Pro Tek Syndicate "Raze the World" Desk Mat O2 + Odac by Mayflower Electronics (Rev A) 
AudioAudioAudioAudio
Sennheiser HD 800 2xKrk Rokit 6 G2 Blue Yeti (Grey) Rode PSA-1 Arm 
Other
Aquaero 6 LT + Aluminum Heatsink 
CPUMotherboardGraphicsRAM
i5 6600k Delid @ 4.848/4.848 Asus z170 Hero MSI GTX 980ti @ 1499/4082 1.25v/134% Power 2 x 8gb Gskills Ripjaws V 3131 16-16-16-32 
Hard DriveHard DriveHard DriveHard Drive
Samsung Pro Series 840 256gb (Celapaleis) 1 TB Samsung Drive (Pack Yak) Samsung Pro Series 850 256gb (Celapaleis Reprise) Phoenix Down (External Backup) 
CoolingCoolingOSMonitor
Noctua D14 Kraken x61 Push-Pull for GPU Windows 10 Pro Catleap 2560x1440 @ 60hz 
KeyboardPowerCaseMouse
CM Storm Trigger Brown Switches EVGA Supernova 1000w P2 Corsair 540 Air Razer Abyssus 
Mouse PadAudioAudioAudio
Steelseries QcK Mini Blue Yeti Microphone Objective Dac + Amp Sescom AB Switch 
AudioAudioAudioAudio
Krk Rokit 6 G2 x2 Radioshack Ground Loop Isolator (For Rokits) Wooaudio Aluminum Headphone Stand Sennheiser HD 800 
AudioOther
Logitech c920 Webcam NZXT Sentry Mix 2 Fan Controller 
  hide details  
Reply
post #8342 of 19539
Hello guys. Ok I need some help. I can't for the life of me get my 4670k cooled by a NH-D14 on a maximus vi hero board stable at 4.4Ghz.

Settings at this time:

Cpu ratio 44
Vcore 1.36 (now, this is my problem right here, should it be this high for such a multi?)
Uncore 35
Vring 1.19 (High right? lower and the problem is the same so I left it)
Vrin (VCCIN on my board if I'm correct) 2.0
No XMP
Mems at 1600Mhz (tried at 1333 didn't make a dif, since this is default I left it)
Mem voltage at 1.6 I believe.

I cannot pass x264 on the 3rd round (should I do x86 or x64?). Temps while doing it are acceptable ~67ºC average. I can't boot with less that 1.33 if I recall and when it boots it just bsods a few moments after. So I'm asking for help, am I doing something wrong? or is my chip that bad?
post #8343 of 19539
Quote:
Originally Posted by Polarityy View Post

Hello guys. Ok I need some help. I can't for the life of me get my 4670k cooled by a NH-D14 on a maximus vi hero board stable at 4.4Ghz.

Settings at this time:

Cpu ratio 44
Vcore 1.36 (now, this is my problem right here, should it be this high for such a multi?)
Uncore 35
Vring 1.19 (High right? lower and the problem is the same so I left it)
Vrin (VCCIN on my board if I'm correct) 2.0
No XMP
Mems at 1600Mhz (tried at 1333 didn't make a dif, since this is default I left it)
Mem voltage at 1.6 I believe.

I cannot pass x264 on the 3rd round (should I do x86 or x64?). Temps while doing it are acceptable ~67ºC average. I can't boot with less that 1.33 if I recall and when it boots it just bsods a few moments after. So I'm asking for help, am I doing something wrong? or is my chip that bad?

I'd start by dropping that VRIN. For that vcore, I would try 1.8...
post #8344 of 19539
Quote:
Originally Posted by bond32 View Post

I'd start by dropping that VRIN. For that vcore, I would try 1.8...

BSOD at 30% 1st pass. More suggestions?
post #8345 of 19539
Quote:
Originally Posted by Polarityy View Post

BSOD at 30% 1st pass. More suggestions?

You seemed to have a below average chip like mine altho im dealing with X45. How much do you need to boot in win at X43 ?
post #8346 of 19539
1.30 or something similar if I'm not mistaken, but its been a while since I tried 43. Even tho 44 is just 100Mhz more its been a headache to get it running properly. When I see the chips a lot of people in this thread have I almost feel like crying. Tried 1.9 Vrin bsod on 1 run 2 pass at 60%.
post #8347 of 19539
Quote:
Originally Posted by Polarityy View Post

1.30 or something similar if I'm not mistaken, but its been a while since I tried 43. Even tho 44 is just 100Mhz more its been a headache to get it running properly. When I see the chips a lot of people in this thread have I almost feel like crying. Tried 1.9 Vrin bsod on 1 run 2 pass at 60%.

Yeah i feel the same ,, it sux to have these chips but running atleast 43-45x makes the performance a tad better but i just tried BF3 with stock settings and the fps are almost the same smile.gif but as we are overclockers one always wants more power out of their chip. Do you get BSOD 124 error ? if so try 1.38vcore and 1.95 VRIN.
post #8348 of 19539
I'm on windows 8.1 so all I got was the usual Whea error or w/e it is called.. Kinda playing it by heart, but yes normally when I bsod I up the voltage a tad and try again. Right now I'm at 1.36vcore and 1.95Vrin, gonna see where it leads.
post #8349 of 19539
Quote:
Originally Posted by Polarityy View Post

I'm on windows 8.1 so all I got was the usual Whea error or w/e it is called.. Kinda playing it by heart, but yes normally when I bsod I up the voltage a tad and try again. Right now I'm at 1.36vcore and 1.95Vrin, gonna see where it leads.


I think its need some more vcore , i can boot with 1.30-31 x45 but i need 1.37-38 it seems. Im still failing with mine and i have passed X264 several times with 15 pass custom loop and played 20 hours BF3 but still its crashing.
post #8350 of 19539
I think I have a problem with x264 sometimes it just stops responding is that due to the OC? or is the program just screwed up in some way?
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Intel CPUs
Overclock.net › Forums › Intel › Intel CPUs › Haswell Overclocking Guide [With Statistics]