post #1 of 1
Thread Starter 
Hey guys! I am just now finishing up my HAF 922/AMD build. I have run into an aesthetics issue that is driving me up a wall. The HAF 922 has a 200mm red LED fan on the front to pull in air. It has two sets of wires. Set one is to the board for power and control. Set two is a 2-wire male connector to the top of the case which connects to a 2-pin female switch. Is there any products I can buy, such as a y-splitter that I can control another fans LEDs through that top switch? Thanks for the help! thumb.gif