Ah, clones, if that was on the same PC, from HDD to SSD, it did not go perfectly.
I would suggest running the INF file installer for your board, since as BrainSplatter said, basic information is missing from the AS SSD display.
Did you clear the BIOS after the clone? That helps to clear up confusion in Windows, etc. Don't forget to reset your BIOS settings if you do.
Did you reboot after the alignment?
The AS SSD results are weird. It looks like the SATA mode is AHCI, given the 4K-64Thrd read results, but the write speeds, besides sequential, are still terrible.
It seems like the clone or something has written to all the NAND on that SSD, causing huge write amplification. The misalignment of course did a similar thing, every write done in the unaligned state caused multiple writes to occur, as the SSD's firmware struggled to write things correctly.
Have you run the SSD Optimizer in the Magician software? Even if you have, do it again now that the SSD seems to be aligned. That might clean things up for you quite a bit. Before doing that, I would suggest doing a Windows Disk Cleanup on the SSD, and then run the Optimizer.