Overclock.net › Forums › Case Mods & Cases › Builds & Case Mods › Case Mods › Pass Thru for LED midplate
New Posts  All Forums:Forum Nav:

Pass Thru for LED midplate

post #1 of 3
Thread Starter 
Hey all!

I'm in the middle of building my LED midplate, and it's approx. 1" thick. I am going to have two tubes going through it, one into the bottom radiator from the pumps, and one going back up out to a block on the board.

I know I can drill holes, use grommets and put the tubing through that way, but I really like the look of having compressions on both sides. I've seen this done, but any advice what parts to use?

I've looked at fill ports and pass thru's, but the longest pass thru I found was Bitspower and it was barely 3/4" long.

Any advice?
post #2 of 3
Make a larger clearance hole in the underlying layers, and only mount the pass thru to the upper layer or two.
post #3 of 3
Thread Starter 
Quote:
Originally Posted by TLHarrell View Post

Make a larger clearance hole in the underlying layers, and only mount the pass thru to the upper layer or two.


Ah, great idea! Thanks!
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Case Mods
Overclock.net › Forums › Case Mods & Cases › Builds & Case Mods › Case Mods › Pass Thru for LED midplate