Originally Posted by ciarlatano
You will be fine with what you have described above in the Luxe. However....were it me.....I would be inclined to use the SW2 as intake and the NF-A14 on the H110i. This is simply because the SW2 have notoriously bad static pressure when used on rads, and that rad is as restrictive as they get. The NF-A14 would perform a bit better on the rad at similar speed/noise levels, while the SW2 will do nicely as intakes. And....the wild card for you....the two F140SP included with the Luxe would probably have the best noise/performance on the rad of any of the fans mentioned. They would actually be the best choice for your rad in that scenario, with the Nocs as intake and exhaust.
The Evolv ATX gets a little tricky, and will likely run a little warmer than the Luxe with your setup. With the added restriction of the Luxe, you would definitely need to lose the SW2 in favor of something with better static pressure. You could very simply use the two F140SP that are included for intakes in the Evolv on your H110i and move your two NF-A14 to the front as intake - again, using the F140SP becomes part of your best configuration. You would also need to isolate the front and rear of the rad - in other words, fill the open space in the rad mount, which is easily done with damping material, tape, cardboard, plastic sheets....I use 3M self-adhesive damping material, it takes about 2 minutes to do the job and you can't see it.
After I could no longer deal with the size of the Primo, I spent a long time debating between the Evolv ATX and the Luxe. I was fortunate that I had both on hand at the time, so I got to do some first hand fitting and trials. I went with the Evolv ATX, but my build is much different than yours and a lot of my decision came down to things like the res I wanted to use fitting cleanly in front of the GPUs, pump mounting location, etc, which are obviously nothing that will be relevant to you. If I was doing a build similar to yours, I would have used the Luxe without question.
First of all thanks for your very detailed reply. This is the 3rd forum where I tried to get some help and the first I actually GET help
I think I will take your advices with that and I will go for the Luxe. The "problem" is I rly want a very silent system and i had 5x 140 mm NF-A14 in my system before. But with the 2 fans on the AiO at full 1200 rpm my system was too loud for my needs :/ I know I'm sensitive in terms of that^^
Then I replaced 2 of them (from the Corsair Radiator) for the bequiet and let them run on full speed and my other 3 NF-A14 I run at 900 rpm and now my system is rly silent while I just got my CPU 1-2° hotter after changing the fans.
The only thing I could maybe do is putting my NF-A14 back on the Radiator when I get the nex Luxe Case and manage them all to 900-1000rpm with the FAN Hub from the case or am I wrong there?
Thanks again for your awesome help