The WHITE Enthoo
hits the shelves
The answer to the UT60 is "it depends" ..... The 360 presents less issues than the 420 in this respect but in my build, the 60 in P/P blocked many of my MoBo features ....some where installation oriented .... i.e. you have no access to 8 pin EPS cable w/o removing bottom fans..... others were blocked access to features like the LED diagnostic panel.
As to what's better.... here's all the data on most commonly used rads compiled from matinsliquidlab site
The UT60 will deliver a whopping 7 more watts using the Phanteks fans @ 1250 rpm.... little less as they don't actually run that high.
XT45-360 = 247 watts in push pull
UT60-360 = 254
XT45-420 = 302
XT45-480 = 296
UT60-480 = 303
As to your question ... The UT60-360 in push delivers 188 watts / the XT45-360 in P/P delivers 247 watts ..... a rad with 2 fans will always always be better than thicker rads w/ one as thicker rads really don't do anything of significance until like 2200 rpm where I'b be leaving the room because of noise. This list is basically "per fan" or "per 120mm of read" ....adding a 2nd fan in push adds around 21% in martins testing which of course will vary by fan (10 - 30%)1250 rpm in push
ST30 - 60 watts
XT45 - 61
UT60 - 63
Monsta - 661400 rpm in push
ST30 - 66 watts
XT45 - 68
UT60 - 70
Monsta - 74
1800 rpm in push
ST30 - 81
XT45 - 86
UT60 - 90
Monsta 80 - 94The real deal here is the XT45-420
..... for one, it's like the rad was made for this case....
1. Ya can place it so the top ports are accessible from the top of the case
2. The XT45-420 delivers about the same cooling as the UT60-480
3. The XT45 ($85) with 6 Phanteks fans ($90) in push pull is about $175.
- XT45-480 w/ fans is $225
- UT60-360 w/ fans is $190
- UT60-480 w/ fans is $250
I have a 420 + 280 in push only with the Phanteks fans the case came with and it keeps the 4770K (4.6 Ghz - 74C)) and twin 780s (25% OC - 39C) at 8.4C Delta T with no filters or grilles in place.... slowing things down and adding the filters brings me up to 12,8C and GPU temps of 44C.
As for the fan question, the Phanteks fans are superb and I wouldn't think of replacing them. And 1900 rpm is a bit screamy noise wise .....I have the Phanteks fans working from about 325 to 850 rpm and they are dead silent at those speeds.
Martin site has loads of fan data but unfortunately he hasn't tested many of the new designs..... SPCR has but there test are on air coolers..... but when ya think about it, air coolers with their tight fin spacing present more of a challenge than 10 fpi rads like you and I are using.
I wanna lift mine off the desk but was am thinking 4 hockey pucks or just 1 x 2's at each and and was wondering how critical placement might be. At this ppoint the thing is too damn heavy to flip.