Originally Posted by doyll
Here's one. A hockey puck under each corner foot would be bigger than needed, but would definitely work. Any kids nearby with with a few square wooden blocks you could steal?
The top side with w/ the circular holes, looks interesting as Im thinning hockey puck with a pin...., I'd cut the pucks outta wood.\ and a pin would keep it from slipping ..... the other idea was two noitched piece at each end so the same reason ... so the case bottom would sit in the notch..... next build I'll turn it up side down and make two sets
Originally Posted by Leeford
Wow, Newegg out of stock already? That was what? 12 hours? Not even enough time to clear the purchase with the wife.
I think I am going to wait for one of the special edition ones anyway, the ones with the black exterior and a white, red, or orange interior.
Now just have to decided between the white or red interior. White would look nicer for my UV lighting plans, but red would really go well with my favorite mobos,. The orange would be the most unique but would have to ditch the Phantek fans for some orange cougars .
It was gone just 3 hours later..... and no "out of stock" message ..... my guess is it was a repeat of last August and then Phanteks went nutz as they promised those w/ pre-orders they would get theirs 1st..... I actually had a confirmed order from newegg, ....... which couldn't happen if it was in the building,...... then was contacted about a delay. My guess is they sitting in warehouse until Phanteks says they can sell.
Originally Posted by Unicr0nhunter
Any new word on when the fan hubs might be made available for sale individually? Last I heard Brian the Phanteks rep was giving an ETA of March.
Last word I got was April
Originally Posted by derfer
Looking seriously at getting this case. Is revision 2 the only thing on the market now? And are there any videos out there of the safe way to remove these panels? And does phanteks sell accessories yet? I need 5 sets of the rubber pads to make the fans match the retail fans.
Originally Posted by Leeford
I am leaving the two LED front fans in place and going to put the 3 remaining included fans on a 420 radiator. I don't have a case yet (waiting for the Black & Red/White/or Orange) but I saw in one review the top is 25mm between the rad mount and filter. Another post says the rubber feet on non-included fans makes the fan 27mm, so I might need these 3 "feetless" ones to go up top. Maybe someone who has put 140mm's on top can weigh in if this is accurate?
At any rate, if I need some rubber feeting between the rad and those particular fans, and Phantek does not have a solution, I will just get something like this:
I only needed 2 sets ..... the pads are not needed on the case mountings..... only needed when used on a rad as having some with and some without would make it wobbely. The 27mm fans fit fine with room to spare. If ya need em, call / e-mail Phanteks and they send em out.
Originally Posted by Gunilla95
Well, I dont know if this person already is with us here. or if you aldready know of him.
but check out his premo build hes doin on his facebook. looks really nice and he has good ideas!
Wow.... that is really interesting, I didn't see the build as I don't do facebook...... but I contacted kier to ask some questions about this build
And mentioned that I was doing a similar build in a Primo when it came out and suggested it for one of his future projects ... I guess he took a liking to it Edited by JackNaylorPE - 4/11/14 at 10:44pm