More done today
Cut out the acrylic panels for the front and rear interior.
Changed the design so the rear is now two pieces (the join is hidden behind the fan), which means I didn't have to drain and strip all components to fit it in there. Held in only by the fan screws (they will be swapped for black ones asap) so it is very easy to remove and re install if needed.
Front is one piece held in with double sided tape-
The top of the front panel- I was going to make a separate cover for the IO cables, but after bending the acrylic tubes with a heat gun I thought I'd give that a go on the acrylic sheet. It worked
Cut out a clear side window. Not sure if I'm going to use it- Still toying with the idea of a custom full acrylic side panel.
And one just because I can-
Not much more to do really. I'm going to polish up that acrylic fitting and swap out some LED's and that's about it.
Just waiting on my thermal paste so I can delid the processor, then I will get the red coolant in.Edited by RomeoKilo - 11/27/13 at 1:42am