HOLD UP, HOLD MY PHONE!!
Won't be able to annotate AS much this time. Pretty busy to say the least.
First up cutting a new cable management piece. Notice the V-bit 45° cut. This is vital to get the piece to actually fit.
Repeat to complete:
You can see now how the 45° was necessary:
Did another couple of tubes for the rear rad:
Installed the fans on the 360. Really cant get over how good these rads and fans are:
A little look in the case internal... suppose it's a bit anticlimax now half the stuff has been taken out:
Back to our old tricks. Really like physically marking stuff:
Then do it all again but with holes:
Installing the cables:
That would be it for today.
Thanks for checking in