post #1 of 1
Thread Starter 
Just got in a PC build, as always I built it outside the case to make sure everything is working, all was fine.

I built it all in the case, cable tidied the cable ect and it wouldnt boot.
Now Im a paranoid system builder so I wear anti static strap but I thought I had broke something so out it all comes again and I build it on the workbench, its all fine again.

Back in the case it goes and I use a power button that I have kicking about thinking it could be the power button on the case, but still nothing.

I now think its a short, made sure all standoffs are correct but still nothing.

Is there anything I can do to fix this issue, short of wrapping the back of the motherboard in electrical tape I have not got a clue.

My old motherboard works fine in the case ....go figure.