Overclock.net › Forums › Intel › Intel - General › Temps higher after delid
New Posts  All Forums:Forum Nav:

Temps higher after delid

post #1 of 4
Thread Starter 
So I delided with Vise and Hammer
During this my IHS got scratched just a little on the sides (Believe on side is raised a little) could this be holding cooler off CPU?

There was still a little black silicon on chip but area of IHS contacting die was clean.

Would I be best to remove IHS and just attach cooler to die?
If i pull IHS back off cpu will I need to reapply Liquid Ultra (Very little in tube)?

Just looking for suggestions what I should do because I don't want to break anything wink.gif

Thanks in advance
post #2 of 4
Since you have already delided it, I would run without. This should give you better temps.
If it's still bad temps, you can try to reseat it with less thermal paste, or another better brand of thermal paste.

Attaching cooler to the die is the whole point of deliding ain't it? wink.gif
    
CPUMotherboardGraphicsRAM
|AMD Phenom II X6 1100T @ 4ghz| |Asus Crosshair IV Formula| |EVGA 780TI Classified| |4x2gb Corsair XMS 1600mhz CL7| 
Hard DriveCoolingOSMonitor
|840 Pro 256gb| |WD Red 2tb| |Corsair H50| |Windows 10 Pro x64| |27" QNIX QX2710 @ 2560x1440 100hz| 
KeyboardPowerCaseMouse
|Logitech G810 Orion Spectrum RGB| |Cooler Master 700w Silent Pro Gold| |Antec 1200 Orange mod| |Logitech G502 Proteus Spectrum RGB|  
AudioAudioAudio
|JBL L890 speakers| |Emotiva XDA-2 receiver| |2x Advanced Acoustic mono amp @ 200w 8ohm| 
  hide details  
Reply
    
CPUMotherboardGraphicsRAM
|AMD Phenom II X6 1100T @ 4ghz| |Asus Crosshair IV Formula| |EVGA 780TI Classified| |4x2gb Corsair XMS 1600mhz CL7| 
Hard DriveCoolingOSMonitor
|840 Pro 256gb| |WD Red 2tb| |Corsair H50| |Windows 10 Pro x64| |27" QNIX QX2710 @ 2560x1440 100hz| 
KeyboardPowerCaseMouse
|Logitech G810 Orion Spectrum RGB| |Cooler Master 700w Silent Pro Gold| |Antec 1200 Orange mod| |Logitech G502 Proteus Spectrum RGB|  
AudioAudioAudio
|JBL L890 speakers| |Emotiva XDA-2 receiver| |2x Advanced Acoustic mono amp @ 200w 8ohm| 
  hide details  
Reply
post #3 of 4
some pics?
Wanted: Wanted: R9 290/X/R9 390/X
$165 (USD) or best offer
  
Reply
Wanted: Wanted: R9 290/X/R9 390/X
$165 (USD) or best offer
  
Reply
post #4 of 4
Thread Starter 
Ended up taking and lapping IHS

Used block and sandpaper and keep running over it to finally get a level surface.

Temps are now at 43 under load running at 3.9GHZ. Also this was on a 4770K

Thanks for all the comments
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Intel - General
Overclock.net › Forums › Intel › Intel - General › Temps higher after delid