Overclock.net › Forums › Components › Mice › Logitech G100s sensor installed crooked - result in cursor moving?
New Posts  All Forums:Forum Nav:

Logitech G100s sensor installed crooked - result in cursor moving?

post #1 of 8
Thread Starter 
After I opended the shell of my G100S I noticed the following:





So you could hopefully see that the modul is on top of the pcb at one side.
At the other side the modul missed the top of pcb and slide next to the pcb.

I noticed a cursor moving (without my action) every few seconds. And if I hammer my desk, the cursor moves also.

But I really wonder wether this behavior could come from the crooked chip.
What do you think?
Have you got a logical explanation that a crooked sensor does ghost movement?

Anyway I will try to solder the chip in the right position...
post #2 of 8
it could be
or
it also could be your desk setup? if your PC + Speaker setup is on your desk near your mouse the vibrations from them can cause the mouse to jitter or move.

i still have them both on my desk but bought a qck heavy (with a hein on top) to dampen the vibrations and now i can hammer my desk and the courser doesnt even budge.
Edited by discoprince - 11/24/13 at 12:55pm
post #3 of 8
Just warm the soldering and press softly the sensor to have it perfectly aligned... that will fix the problem.
post #4 of 8
Thread Starter 
Thanks, but after I do my best to position the sensor in his right position, the problem is still the same. For testing speakers were turned off.

No other mice shows these effects.

I think this must be another error. I also think this crooked sensor did not caused this problem....
post #5 of 8
Quote:
Originally Posted by CeeSA View Post

Thanks, but after I do my best to position the sensor in his right position, the problem is still the same. For testing speakers were turned off.

No other mice shows these effects.

I think this must be another error. I also think this crooked sensor did not caused this problem....

Did you put it right ? Is it aligned with the pcb now ?
post #6 of 8
Thread Starter 
yes, sensor is know "laying" on both sides of the pcb. Looks visually straight.
post #7 of 8
Quote:
Originally Posted by CeeSA View Post

yes, sensor is know "laying" on both sides of the pcb. Looks visually straight.
Descrube your problem more preciisely
post #8 of 8
Thread Starter 
Sorry, I don't get what you mean (my english is bad...)

The sensor is now in it's position, like it should be. It is straight as possible by manuelly do so.

Problem is still:
I noticed a cursor moving (without my action) every few seconds. And if I hammer my desk, the cursor moves also.
Edited by CeeSA - 11/25/13 at 2:32am
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Mice
Overclock.net › Forums › Components › Mice › Logitech G100s sensor installed crooked - result in cursor moving?